Basement Stairs Finishing Ideas – Many homes have basement stairs that use rugged board rails for minimum safety requirements. When updating your home, it is a good idea to replace the rough plates with a safe and attractive middle wall, especially if you are finishing the basement in the stairwell area. An average wall is quite simple to build and the final appearance is a significant improvement over rough plates.
Remove any existing rough handrails on the side of the stair where you want to install the partial wall. Measure the side of the ladder of the vertical pipeline in front of where the new partial wall will end. Measure the width of each tread. It is likely that the threats vary. Look for the shortest thread. Lay a 2-by-4-inch board along the floor, starting where you want the wall to begin and stop where you want the wall to end.
24 Picture Gallery: Basement Stairs Finishing Ideas in Remodel It
Plastic sheet cut to cover the concrete around the tape. Wood should never rest directly on the concrete. Cut two 2-by-4 inch boards 42 inches long. Place the plates on the wooden plate at the bottom of the ladder. Square of the ends. Add the block between the outside of the stair rail and the wall to help make the wall stronger. Remove the step ladder and risers before installing the drywall. Unscrew the steps. Apply out of corners on the lower edge of the drywall. Install the fourth round with glue and finishing nails.
This post topic: Basement Stairs